The moisture content of the material after drying is greater than the specified value, and its elimination method is to control the production capacity of the dryer and increase or decrease the supply of heat.
2. The rolling ring swings to the cylinder. The reason is that the side of the concave joint of the rolling ring is not clamped. The elimination method is to use a backing plate to keep the rolling ring and the concave joint evenly and properly clamped to prevent over-tightening and prone to accidents.
3. The meshing gap between the large gear and the small gear is destroyed. The reason is a. The tug wheel is worn B. The block wheel is worn c. The pinion is worn. The elimination method is turning or replacing according to the wear condition, or it can be installed on the opposite side or updated in pairs.
4. The whole body vibration is caused by a. The connection between the tugwheel device and the base is damaged. The elimination method is to correct the fastening connection part to make it in the correct position; B. the side of the rolling ring is worn. The elimination method is to turn or replace the rolling ring according to the degree of wear.